forked from Qortal/Brooklyn
You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
58 lines
1.7 KiB
58 lines
1.7 KiB
/* SPDX-License-Identifier: GPL-2.0-only */ |
|
/* |
|
* wm8962.h -- WM8962 Soc Audio driver platform data |
|
*/ |
|
|
|
#ifndef _WM8962_PDATA_H |
|
#define _WM8962_PDATA_H |
|
|
|
#define WM8962_MAX_GPIO 6 |
|
|
|
/* Use to set GPIO default values to zero */ |
|
#define WM8962_GPIO_SET 0x10000 |
|
|
|
#define WM8962_GPIO_FN_CLKOUT 0 |
|
#define WM8962_GPIO_FN_LOGIC 1 |
|
#define WM8962_GPIO_FN_SDOUT 2 |
|
#define WM8962_GPIO_FN_IRQ 3 |
|
#define WM8962_GPIO_FN_THERMAL 4 |
|
#define WM8962_GPIO_FN_PLL2_LOCK 6 |
|
#define WM8962_GPIO_FN_PLL3_LOCK 7 |
|
#define WM8962_GPIO_FN_FLL_LOCK 9 |
|
#define WM8962_GPIO_FN_DRC_ACT 10 |
|
#define WM8962_GPIO_FN_WSEQ_DONE 11 |
|
#define WM8962_GPIO_FN_ALC_NG_ACT 12 |
|
#define WM8962_GPIO_FN_ALC_PEAK_LIMIT 13 |
|
#define WM8962_GPIO_FN_ALC_SATURATION 14 |
|
#define WM8962_GPIO_FN_ALC_LEVEL_THR 15 |
|
#define WM8962_GPIO_FN_ALC_LEVEL_LOCK 16 |
|
#define WM8962_GPIO_FN_FIFO_ERR 17 |
|
#define WM8962_GPIO_FN_OPCLK 18 |
|
#define WM8962_GPIO_FN_DMICCLK 19 |
|
#define WM8962_GPIO_FN_DMICDAT 20 |
|
#define WM8962_GPIO_FN_MICD 21 |
|
#define WM8962_GPIO_FN_MICSCD 22 |
|
|
|
struct wm8962_pdata { |
|
struct clk *mclk; |
|
int gpio_base; |
|
u32 gpio_init[WM8962_MAX_GPIO]; |
|
|
|
/* Setup for microphone detection, raw value to be written to |
|
* R48(0x30) - only microphone related bits will be updated. |
|
* Detection may be enabled here for use with signals brought |
|
* out on the GPIOs. */ |
|
u32 mic_cfg; |
|
|
|
bool irq_active_low; |
|
|
|
bool spk_mono; /* Speaker outputs tied together as mono */ |
|
|
|
/** |
|
* This flag should be set if one or both IN4 inputs is wired |
|
* in a DC measurement configuration. |
|
*/ |
|
bool in4_dc_measure; |
|
}; |
|
|
|
#endif
|
|
|