forked from Qortal/Brooklyn
You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
57 lines
2.1 KiB
57 lines
2.1 KiB
VIA VT8500 and Wondermedia WM8xxx-series pinmux/gpio controller |
|
|
|
These SoCs contain a combined Pinmux/GPIO module. Each pin may operate as |
|
either a GPIO in, GPIO out or as an alternate function (I2C, SPI etc). |
|
|
|
Required properties: |
|
- compatible: "via,vt8500-pinctrl", "wm,wm8505-pinctrl", "wm,wm8650-pinctrl", |
|
"wm8750-pinctrl" or "wm,wm8850-pinctrl" |
|
- reg: Should contain the physical address of the module's registers. |
|
- interrupt-controller: Marks the device node as an interrupt controller. |
|
- #interrupt-cells: Should be two. |
|
- gpio-controller: Marks the device node as a GPIO controller. |
|
- #gpio-cells : Should be two. The first cell is the pin number and the |
|
second cell is used to specify optional parameters. |
|
bit 0 - active low |
|
|
|
Please refer to ../gpio/gpio.txt for a general description of GPIO bindings. |
|
|
|
Please refer to pinctrl-bindings.txt in this directory for details of the |
|
common pinctrl bindings used by client devices, including the meaning of the |
|
phrase "pin configuration node". |
|
|
|
Each pin configuration node lists the pin(s) to which it applies, and one or |
|
more of the mux functions to select on those pin(s), and pull-up/down |
|
configuration. Each subnode only affects those parameters that are explicitly |
|
listed. In other words, a subnode that lists only a mux function implies no |
|
information about any pull configuration. Similarly, a subnode that lists only |
|
a pull parameter implies no information about the mux function. |
|
|
|
Required subnode-properties: |
|
- wm,pins: An array of cells. Each cell contains the ID of a pin. |
|
|
|
Optional subnode-properties: |
|
- wm,function: Integer, containing the function to mux to the pin(s): |
|
0: GPIO in |
|
1: GPIO out |
|
2: alternate |
|
|
|
- wm,pull: Integer, representing the pull-down/up to apply to the pin(s): |
|
0: none |
|
1: down |
|
2: up |
|
|
|
Each of wm,function and wm,pull may contain either a single value which |
|
will be applied to all pins in wm,pins, or one value for each entry in |
|
wm,pins. |
|
|
|
Example: |
|
|
|
pinctrl: pinctrl { |
|
compatible = "wm,wm8505-pinctrl"; |
|
reg = <0xD8110000 0x10000>; |
|
interrupt-controller; |
|
#interrupt-cells = <2>; |
|
gpio-controller; |
|
#gpio-cells = <2>; |
|
};
|
|
|