mirror of https://github.com/Qortal/Brooklyn
You can not select more than 25 topics
Topics must start with a letter or number, can include dashes ('-') and can be up to 35 characters long.
64 lines
1.7 KiB
64 lines
1.7 KiB
Kernel driver ltc4260 |
|
===================== |
|
|
|
Supported chips: |
|
|
|
* Linear Technology LTC4260 |
|
|
|
Prefix: 'ltc4260' |
|
|
|
Addresses scanned: - |
|
|
|
Datasheet: |
|
|
|
http://cds.linear.com/docs/en/datasheet/4260fc.pdf |
|
|
|
Author: Guenter Roeck <[email protected]> |
|
|
|
|
|
Description |
|
----------- |
|
|
|
The LTC4260 Hot Swap controller allows a board to be safely inserted |
|
and removed from a live backplane. |
|
|
|
|
|
Usage Notes |
|
----------- |
|
|
|
This driver does not probe for LTC4260 devices, since there is no register |
|
which can be safely used to identify the chip. You will have to instantiate |
|
the devices explicitly. |
|
|
|
Example: the following will load the driver for an LTC4260 at address 0x10 |
|
on I2C bus #1:: |
|
|
|
$ modprobe ltc4260 |
|
$ echo ltc4260 0x10 > /sys/bus/i2c/devices/i2c-1/new_device |
|
|
|
|
|
Sysfs entries |
|
------------- |
|
|
|
Voltage readings provided by this driver are reported as obtained from the ADC |
|
registers. If a set of voltage divider resistors is installed, calculate the |
|
real voltage by multiplying the reported value with (R1+R2)/R2, where R1 is the |
|
value of the divider resistor against the measured voltage and R2 is the value |
|
of the divider resistor against Ground. |
|
|
|
Current reading provided by this driver is reported as obtained from the ADC |
|
Current Sense register. The reported value assumes that a 1 mOhm sense resistor |
|
is installed. If a different sense resistor is installed, calculate the real |
|
current by dividing the reported value by the sense resistor value in mOhm. |
|
|
|
======================= ======================= |
|
in1_input SOURCE voltage (mV) |
|
in1_min_alarm Undervoltage alarm |
|
in1_max_alarm Overvoltage alarm |
|
|
|
in2_input ADIN voltage (mV) |
|
in2_alarm Power bad alarm |
|
|
|
curr1_input SENSE current (mA) |
|
curr1_alarm SENSE overcurrent alarm |
|
======================= =======================
|
|
|